Carbolite nanodac - Manual (Page 67)

nanodac™
65
MC27 –EN–1.04
6.3 PARAMETER EXPLORER
This view can be displayed:
1.
by clicking on the ‘Parameter Explorer’ toolbar icon,
2. by double clicking on the relevant block in the tree pane or in the graphical wiring editor
3. by selecting ‘Function Block View’ from the Function block context menu in the Graphical wiring
Editor.
4. by selecting ‘parameter Explorer from the ‘View’ menu
5. by using the short cut <Alt>+<Enter>
In each case the function block parameters appear in the iTools window in tabular form, such as the
example in figure 3.4a, below.
Figure 3.4a Parameter table example
The figure above shows the default table layout. Columns can be added/deleted from the view using the
‘Columns’ item of the Explorer or context menus (figure 3.4b).