Carlin 201GAS - Manual (Page 19)

Model 201GAS burner — Instruction manual
Carlin part number MN201GAS Rev. 03/14/11
– 19 –
Where appliance instructions differ from this manual, follow the appliance instructions.
8. Dimension and mounting information
Figure 10 Dimensional data
Mounting burner to appliance
The universal flange supplied with 201GAS burners is
intended only for firing chambers with negative overfire pres-
sure. For pressurized firing, you must obtain a burner with a
welded flange, designed for use with the appliance. You can
also use the optional Forced draft flange. Failure to comply
could result in severe personal injury, death or substantial
property damage.
Prepare the burner opening on the front of the appliance as shown in Fig-
ure 11 if not already supplied. See page 7 to determine the location of the
flange on the burner air tube. Tighten the flange locking screws firmly.
Figure 11 Flange mounting information