CCTV Camera Pros iDVR-PRO Video Surveillance DVR for CCTV Camera Pros - Manual (Page 28)

28
S S Y Y S S T T E E M M S S E E T T U U P P
SYSTEM NAME : It is used so that notification emails can be identified.
F/W UPDATE : Firmware updates may be released periodically to enhance system performance and add extra features.
The operator can upgrade the firmware using a USB memory stick.
After inserting the F/W in USB or CD/DVD, Press UPDATE . Then , below menu will appear.
After selecting the F/W from F/W list, press UPGRADE .
Then, F/W upgrade is started.
FACTORY DEFAULT : If settings have been changed , which cause erratic behavior, the factory default settings
can be loaded.
SYSTEM DATA : System settings can be saved to a USB memory stick. The settings can be reloaded
in case of accidental factory reset or can be transferred to another DVR if multiple
units need to be installed with the same settings. All information is saved apart from
network settings and system name.
PASSWORD: Determines the PASSWORD ON/OFF to enter specific menu.
SYSTEM : CONTROL DEVICE
This will allow up to 254 DVRs to be controlled from the same keyboard.
SYSTEM ID : If more than one DVR is connected on the same RS485 bus, each one must have a unique ID.
Note : If using more than one DVR on stack, each DVR must have a unique ID for control by remote controller.
PROTOCOL : Must be set by Control Device.
BAUD RATE : Must be set to match the baud rate of the PTZ controller.