CCTV Camera Pros Geovision 8.2 Multicam Digital Surveillance System - Manual (Page 84)

70
7. Click the Accept check box to make other options available.
8. Use the Mask Filter function to ignore any motion detection within a certain area if necessary.
9. Click the Define Object button.
10. Use the mouse to outline the max and min detection regions separately on the screen. Every time
when finishing an outlining, you will be prompted to select Maximum Size or Minimum Size. See
the illustration below.
Figure 1-64 Defining the min. and max. detection size
11. Click the items of Show Max and Show Min in the lower of the window one by one to check your
defined sizes.
12. Click the Done button to finish the defining.
13. Click the Save Reference Image button to save the image as a reference view.
14. To set up other options, see Other controls in the Video Object Setup window later in this chapter.
15. Click the OK button to apply the settings and close the window.
16. Start camera monitoring for the application.
When an unattended object appears and remains stationary for 9 seconds, its location will be
highlighted, the selected alarm and output will be activated, and the event will be recorded in System
Log for later retrieval.