COATS Vero Series Wheel Balancer User Manual
Page 21
Important: Always read and follow instructions.
• 15
Basic Wheel Data Entry
1.
Direct Select™ an Inboard weight location (Clip 1,
or T1 Tape) and an Outboard weight location (T2 Tape,
T3 Tape or Clip 2).
2.
Position offset arm at clip weight location; wait for
BEEP (A & D enters automatically).
If the T2 Tape location is selected, then move the
offset arm from the clip weight location to the inner
area of the wheel; up against the rim at the outboard
weight placement location; wait for BEEP (A2 & D2
enters automatically).
3.
Return offset arm to the home position.
4.
Lower balancer hood to enter the W measurement
automatically using the hood sonar (width sensor) and
spin wheel.
Entering Wheel Dimensions Manually
Information entered into the balancer software for A,
W, and D can be changed anytime during a balancing
procedure by entering the measurements manually. The
balancer will recalculate weights and positions based
on the new measurements. Select the DIM On Icon to
access wheel dimension keypad, see page 11.
Wheel Offset - A
1.
Press the A (wheel offset) icon.
2.
Position offset arm at weight location on wheel and
read the number on the offset arm gauge, at the cabinet
(this is the correct offset A DIM).
3.
Using the keypad, enter the A measurement value
including a decimal.
Wheel Diameter - D
1.
Press the D (wheel diameter) icon.
2.
Inspect mounted tire sidewall to determine the
exact diameter this is printed on the tire.
3.
Using the keypad, enter the D measurement value
including a decimal to match the tire sidewall size.
Wheel Width - W
1.
Press the W (wheel width) icon.
2.
Use the plastic calipers provided with the wheel
balancer to measure the wheel width.
Figure 22 - Caliper Placement On Wheel
3.
Using the keypad, enter the W measurement value
including a decimal to match measured caliper width of
mounted rim.