Belkin OMNIGUARD F6C110-RKM-2U - Manual (Page 11)

SOFTWARE FEATURES & INSTALLATION
20
SOFTWARE FEATURES & INSTALLATION
21
Communications Port Connection
Setting Up OmniGuard Power Management Software and The Interface Cable
Power Management software and interface cable kits can be used with the UPS.
Use only approved interface cables with this UPS. Connect the interface cable to
the 9-pin communication port on the rear panel of the UPS. Secure the
connector to the UPS via the screws on the connector housing. Connect the
other end of the cable to the device or computer that will be
monitoring/controlling the UPS. Please check the setup instructions in the
software manual located with the CD.
Setting Up Windows Internal Power Management for UPS Service
Note 1: Wake Up and Auto Power-On ATX PC
When AC returns, if the user wants the UPS to power up the PC equipped with
ATX power, our UPS has two methods in order to do this function:
1. Enable the wake-up by modem in the PC BIOS, and then connect the UPS
and PC with RS232 cable. When AC returns, the UPS will send a signal to
start up the PC by RS232 cable.
2. Enable the AC return restart in the PC BIOS (if your PC BIOS can support
this function), and when the AC returns, then the PC will start up directly.
If you don’t need to have your PC auto power on after auto shutdown, you may
just set up Windows internal power management for UPS service as follows:
When there is a utility failure, the UPS will send the AC-fail and low-battery
signals to the PC, and Windows will shut down and send back to the UPS a
shutdown signal. The UPS will be off automatically after the PC is off. The UPS
will be on automatically when utility is recovered. The PC will assume the power
from your UPS. If you have set up your PC to wake-up or auto restart in BIOS as
described in the foregoing note, your PC will be turned on automatically.
1. Open your Windows
2000 Control Panel by
clicking on “Start”,
“Setting”, “Control
Panel”.
2. Double-click on the
Control Panel’s
“Administrative Tools”
icon.
3. Double-click the
“Services” icon.