Bissell PowerSteamer 1693 series - Manual (Page 6)

6
Lift the Tank-in-Tank handle. The handle locks the lid in
place. Carry the Tank-in-Tank like a bucket to fill at the sink.
Set the Tank down and rotate the handle forward to
unlatch the Lid. Lift off and set the Lid aside.
Using the Measuring Cup, pour BISSELL Deep Cleaning
Formula into the mouth of the bladder.
Fill to the bottom of the neck with hot tap water. Do not
boil or microwave water.
NOTE: Fill slowly to reduce sudsing.
Replace the Tank Lid, matching the Lid and Tank edges.
Rotate the handle to carrying position. Replace Tank in
machine base, seating firmly in place. Rotate handle back
down to latched position.
NOTE: Remove the Tank-in-Tank, following step 1 on
page 5 and step 2 above.
Carry the Tank-in-Tank, like a bucket, to the sink. Remove
Tank Lid. Pour out dirty water.
After each use, remove and rinse the Lint Screen located
on the Tank Lid.
Remove Tank Lid.
Remove Lint Screen and rinse under faucet.
Remove any debris caught in Lint Screen.
Reinsert Lint Screen on Tank Lid. The screen will
click into place.
Replace Tank Lid.
Refill with cleaning solution and clean tap water—follow
steps 2-5 above.
When a cleaning job is complete, rinse out the Tank-in-Tank
by running clean water between the bladder and the tank.
Return the Tank-in-Tank to the machine, follow
step 6 above.
Refer to the Storage section on page 8 for final cleanup.
To Fill The Tank-in-Tank Continued
2.
3.
4.
2
3
5.
6.
Lift and Carry
Rotate Handle
to Unlatch
1.
2.
3.
4.
5.
6.
Tip:
A special red float device in
the tank will cause the clean-
er to stop removing solution
from the carpet. The motor
sound will rise in pitch to let
you know the dirty water tank
is full.
When It’s Time To Empty The Tank-in-Tank
A.
B.
C.
D.
4
6
5
1
2 Lint Screen