Bissell PowerSteamer 1693 series - Manual (Page 7)

7
This provides floor or upholstery cleaning with the turn
of a dial. For carpet/floor cleaning make sure the dial
is set to FLOOR CLEANING. For upholstery or fabric
cleaning, attach the Tough Stain Tool to the Flex Hose,
switch to Tools Settings and the PowerSteamer is
ready to clean upholstery, fabrics and more*
* Set the switch to FLOOR CLEANING when cleaning
carpets, or set it to TOOLS/PRETREAT when using
the Flex Hose attachments.
Plan activities to give carpet time to dry.
Remove easily moved furniture from the room (chairs,
lamps, coffee tables, etc.).
Vacuum thoroughly to pick up loose debris and pet hair
before using the PowerSteamer.
Plan your cleaning route to leave an exit path. It is best to
begin cleaning in the corner farthest from your exit.
NOTE:You may notice hair and debris deposits on
carpet that were loosened by brushing action
(especially with newer carpets that have never been
deep cleaned before). This debris should be picked
up by hand and thrown away.
Plug the PowerSteamer into a proper outlet and turn ON
the Power Switch.
While pressing the Spray Release Trigger, make one slow
forward and back wet pass. Let the BISSELL Advanced
Deep Cleaning Formula and DirtLifter Brush do the work
for you.
Caution: Do not overwet.
Release the Trigger and make one slow forward and back
pass over the same area to remove any residual dirty water.
Repeat cleaning passes without pressing the Trigger until
you can’t see any more water being suctioned up.
When cleaning job is complete, refer to the
Maintenance/Storage section on page 8.
ReadyTools ™ Dial
TOO LS
PRE TRE AT
FLO OR CLE ANI NG
How To Clean Carpets
1.
2.
3.
4.
Normal Cleaning
1.
2.
3.
4.
5.
2
4'
3'
1
3
4
5 6
7
9 10 11 12
EXIT
STAR T
HERE
Tip:
Thorough vacuuming
before deep cleaning
will prevent early
clogging of the
lint trap.