Bissell PowerSteamer 1693 series - Manual (Page 9)

9
NOTE: Turn off machine and unplug from wall outlet.
Step on Handle Release pedal and recline Handle on floor
(see illustration).
Remove the Tank-in-Tank. Set aside (see illustration).
Remove the Belt Access Door located near the ReadyTools Dial.
Insert a flathead screwdriver into the slot nearest the handle to
gently pry off the door (see illustration).
Turn the machine onto its side so the belt access area is facing
upward (see illustrations).
On the bottom of the machine, near the belt access area, is a
White Retainer Plate that holds the black Brush Arm and Brush
in place. Using a Phillips head screwdriver remove the screw
that holds the White Retainer Plate in place. Set White Retainer
Plate and Phillips head screw aside (see illustrations).
Remove the black Brush Arm that holds the Brush in place. Set
the black Brush Arm aside (see illustrations).
Locate and remove the broken Pump Belt.
With the unit still on its side, loop one end of the
replacement Pump Belt around the Red Pump Pulley and the
other end around the silver motor shaft (see
illustration). Do not twist the replacement Pump Belt.
Re-install the Brush into the base of the unit.
Place the black Brush Arm onto the Brush and slide black Brush
Arm into original position (see illustrations). Reattach White
Retainer Plate and secure with screw.
Pump Belt Replacement
To Remove Broken Pump Belt
1.
2.
3.
4.
5.
6.
7.
1
2
3
5
4
6
7
White
Retainer Plate
To Replace Broken Pump Belt
1
2
3
1.
2.
3.