CounterPath Bria 3.1 for Mac User Guide - Enterprise Deployments - Manual (Page 60)

CounterPath Corporation
56
Field Description
Headset Mode
Microphone
Speaker Change these fields only if you want to override the devices that Bria automatically selected.
In both these fields, select the headset you are using.
The headset is the device that is usually used for audio out (the sound you hear) and audio in
(recording your voice). The only situation in which the headset is not used is when the Speaker
Phone button on the dialpad is pressed.
Therefore, unless you will always be using Bria in speakerphone mode, you must make a selection
here.
Select the headset in both the Speaker device field and Microphone device field.
Zero touch device
configuration Typically, leave on. When device configuration is on, if you change your audio or video device,
Bria will automatically detect the new device and start using it.
Test Devices For information on the Test Devices button, see “Troubleshooting” on page 61.
Speakerphone Mode
Microphone Change this field only if you want to override the devices that Bria automatically selected.
Make the appropriate choice:
• Select the device that you want to use for audio in (recording your voice) when the Speaker
Phone button is pressed.
It can be any microphone: it does not have to be the microphone on the device you specified as
the speaker device. For example, it can be the microphone on your camera.
• Select None if you do not have a speaker phone. The Speaker Phone button on the dialpad is
disabled.
Speaker Change this field only if you want to override the devices that Bria automatically selected.
Make the appropriate choice:
• Select the device that you want to use for audio out (the sound you hear) when the Speaker
Phone button is pressed. Make sure you select a speaker device (not the headset).
• Select None if you do not have a speaker phone. The Speaker Phone button on the dialpad is
disabled.
Other Devices
Ring on The device where you want to hear the phone ringing.
Change this field only if you want to override the devices that Bria automatically selected.
Volume The volume of the ringer.
Camera This field appears only on versions of Bria that include video functionality.
Change this field only if you want to override the devices that Bria automatically selected.
Select the camera model.
Resolution Leave at standard, or change the size as follows:
• Set it to high if you have a good camera and a computer with a fast CPU. You will know that you
have set the size too large if:
Your computer slows down (the video is using too much CPU)
The video shows black areas or is slow or jerky.
• Typically set it to low only in special situations, for example, when using wi-fi in a hotel. You
will know that you have set the size too small if the video is fuzzy.
This field is identical to the Resolution field in Media Quality > Video Quality.
Deskphone Setup If you are set up with a deskphone, click to configure the URI of your deskphone, in order to work
in deskphone mode. See page 26.