Dascom 7206 Peeler Installation and User Guide - Manual (Page 11)

– 11 –
3 How to operate
3-1 Operation
3-1-4 Initial value of peeling position
The paper position for peeling off the label can be adjusted in the printers menu. See
an excerpt of the printer menu and the web panel.
To adjust the peeling position, designate the feeding amount from the reference
point to the peeling position with the command STX f or STX Kf. The value with
this command will be effective until the resetting is performed. (For details, see the
separate Command Reference.)
Liner
Peeling plate
Center of platen
Sensor reference point
Label f = 256 (2.56 in, 65.00 mm)
9.1 mm
(0.36 in)
Middle point
between labels
55.9 mm (2.2 in)