Dascom 7206 Peeler Installation and User Guide - Manual (Page 12)

– 12 –
3 How to operate
3-1 Operation
3-1-5 Peeler commands
The following are the peeler commands. For details of each command, see the
separate Command Reference.
Peeling position designated command STX f, STX Kf
This command designates the feeding amount from the reference point to the
peeling position.
Software switch setting command STX V
This command temporarily changes the contents of the option function setting in a
nonvolatile memory in the printer. With this command, the peeler function is turned
ON or OFF temporarily.
Note: If the label is at peeling position when the peeler function is selected, the
medial will not feed even if the Feed key is pressed. In this case, remove
the label first.