Dascom T2265+ Quick Installation Guide Cutting Device - Manual (Page 10)

Installation Quick start guide
8
` Installing the cut device
When the fanfold paper is in the park position you can install the cut device. Pro-
ceed as follows:
Turn off the printer first!
First remove the soundproofing cover* from your printer by
tilting it at a 45 degree angle and then pulling up (
A ).
Then remove the front cover ( B ). To do this, raise the cover
to an angle of 45 degrees. Then raise the right side of the
cover slightly and subsequently pull it out also on the left
side by applying gentle pressure towards the right.
STOP
A
* Not available on some printer models.
B
QSG2280+2380_Cutdevice_en.fm Seite 8 Donnerstag, 20. März 2008 3:22 15