Dascom T2265+ Quick Installation Guide Cutting Device - Manual (Page 11)

Quick start guide Installation
9
ENGLISH
Now place the cover supplied on the printer. This cover
replaces the front cover previously removed and serves as a
support for the feed mechanism. Position this cover at an
angle of 45 degrees on top of the printer as shown in the
figure.
First place the recess on the left side of the cover in the
mounting pin on the printer (n). Then insert the holder on
the right side (o) into the pin on the printer and turn the
cover down.
Fold the back cover up (n) and remove it from the top (o).
QSG2280+2380_Cutdevice_en.fm Seite 9 Donnerstag, 20. März 2008 3:22 15