Dascom T2150 User Guide User Manual
Dascom Printers
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Table of contents
- Introduction
- Printer at a glance
- Installation
- The control panel
- Changing the ribbon cassette
- Printer drivers
- Paper handling
- Settings
- The Menu
- Programming via the control panel
- Enabling access to menu mode
- Calling up the menu
- Menu configurations
- Menu handling
- Menu structure
- Menu parameters
- Printing out menu configurations (Print)
- Loading menu configurations (Menu)
- Reset to default values (Reset)
- Quietmode (Quietm.)
- Selecting font (Font)
- Setting character density (CPI)
- Setting line spacing (LPI)
- Skiping perforation (Skip)
- Selecting start signal for escape sequence (ESCChar)
- Selecting emulation (Emulate)
- Bidirectional printing (Bidir)
- Settings for interfaces (I/O)
- Serial interface (Serial)
- Selecting interface (Interf.)
- Interface buffer (Buffer)
- Ethernet interface (ETH-EXT) option
- Selecting character set (CG-Tab)
- IBM character set (CharSet)
- National character set (Country)
- Slashed zero (Sl.Zero)
- Automatic carriage return (Auto-CR)
- Automatic line feed (Auto-LF)
- Menu lock (MenLock)
- Language (Language)
- Paper parameters (Paper)
- View and tear position (AutoTear)
- Line length (Width)
- Barcode (Barcode)
- Normal characters and barcode (Barmode)
- Form feed mode (FFmode)
- Setting and activating options (PapOpt)
- Setting the left margin (LeftMrg)
- Setting the right margin (RightMrg)
- Local copy (screen print) from a Coax or Coax/IPDS (FFaftLC)
- Enable/Disable Paper Handling Features (Paphand)
- Menu settings (example)
- Advanced menu
- Test functions
- Advanced settings
- Form length (Forml)
- Automatic gap adjustment (AGA)
- Paper handling (Paphand)
- Bidirectional parallel interface (CX-bid)
- Line wrap (Wrap)
- Beep at paper end (Sound)
- Deactivate single sheet feeder (Single)
- Settings for paper with dark back (Pap.back)
- Setting for printing copy paper (HvyForm)
- Power save mode (Sleepmod)
- Serial number (SerialN)
- Asset number (AssetN)
- Graphic Print Speed (GrSpeed)
- Improvement of graphic and barcode print quality (GrFreq)
- Activate PJL language (Jobcntl)
- Increased print speed for 17.1 and 20 cpi (HS-Draft)
- Troubleshooting
- Care and maintenance
- Specifications
- Character sets
- Emulations
- Interfaces
- Options and accessories
- Index