Dolan-Jenner MH100 - Manual

Voltage Selection:
The MH100 illuminator operates at 115 VAC 50/60 Hz.
Fiber Optic Connection
Notice: Do not operate the illuminator without the fiber optic connected to the illuminator.
Loosen the fiber optic nosepiece thumbscrew.
Insert the fiber optic into the illuminator nosepiece.
Tighten the thumbscrew by hand to make a secure connection to the fiber optic. Use of pliers or other tools
is not recommended.
Two nosepiece styles are available with the MH100 series of fiber optic illuminators. A-type with a 0.985 in.
(25mm) ID, or B-type with a 0.590 in. (15mm) ID smaller than the 0.985 in. ID.
©2002 Dolan-Jenner Industries, 159 Swanson Rd., Boxborough, MA 01719
978-263-1400, FAX: 978-266-1618, 1-800-83-FIBER, http://www.dolan-jenner.com 05-530016-0000 Rev. C1 11/13
® Fiber-Lite
Operation Manual
A PRODUCT OF DOLAN-JENNER INDUSTRIES
MH100 ILLUMINATOR
Operation
Insert the power cord into the power entry module at the rear of the illuminator. Next, insert the power cord into a 3 wire
grounded AC power receptacle. Use only approved power cord supplied with the illuminator.
Press the ON(1)/OFF(0) rocker switch on the front panel to ON(1). The illuminator will light and is ready for service. The Metal
Halide Lamp may take three (3) to five (5) minutes to achieve full intensity. If the illuminator is turned Off, wait 10 to 15 minutes
prior to turning the illuminator On again. The MH100 is rated to run continuously. Frequent OFF / ON cycling may reduce lamp
life.
WARNING
ULTRAVIOLET LIGHT HAZARD
Always operate with fiber optic and
UV/IR filter in place.
Always remove power before replacing lamp.
Never look into fiber optic port.
Never defeat power interlock switch.
Never look into fan opening while operating.