Dolan-Jenner A242 - Manual

INTRODUCTION
OPERATION
MANUAL INTENSITY CONTROL
The A-241 and A-242 series is a family of 150 Watt, highly regulated, DC powered quartz halogen fiber optic illuminators. The
A-241 and A-242 illuminators are designed for a wide range of applications from laboratory and industrial illumination
applications to precise machine vision illumination. The A-241 illuminator consists of an A-241P power supply unit and one(1)
A-241L lamp module. The A-242 illuminator consists of an A-242P power supply unit and two(2) A-241L lamp modules.
Insert the power cord into the power entry module at the rear of the power supply. Next, insert the power cord into a 3 wire
grounded AC power receptacle.
(The illuminator power
supply comes set from the factory as either 115 VAC or 230 VAC. Contact the Factory if you desired operation at an alternate
voltage.)
Connect the lamp power cable(s) to the A-241L lamp module(s) (A-242 has two(2) lamp power cables).
Press the ON(1)/OFF(0) rocker switch on the front panel to ON(1). The illuminator will light and is ready for service.
All the A-241P/A-242P series illuminators are equipped with a front panel, rotary solid state intensity control. The 0 position
(when control is turned fully counter-clockwise) corresponds to the lowest illuminator intensity. The 100 position (when control
is turned fully clockwise) corresponds to the highest illuminator intensity.
Use only approved power cord supplied with the illuminator.
Continuous operation of the illuminator at the highest intensity level will yield rated lamp life. Operating the
illuminator at reduced intensity can result in significantly extended lamp life.
NOTE:
Operation Manual
A241 / A242 DC REGULATED
FIBER OPTIC ILLUMINATORS
A Product of Dolan Jenner Industries
Fiber-Lite ®
REMOTE INTERFACE
To enable the remote interface move the PANEL/REMOTE switch on the front panel to the REMOTE position. When the switch
is in the REMOTE position, the front panel intensity control is not active. If the Remote Intensity Control Signal is not connected,
the illuminator will run at the maximum intensity setting until the Remote Intensity Control Signal is connected.
Decrease Increase
Decrease Increase
Page 1 A241P / A242P