Dolan-Jenner DC950 - Manual

Setup
Voltage Selection:
The DC950 illuminator has universal AC voltage input. Connect the appropriate AC line cord to the
DC950 and connect to an AC power receptacle. The DC950 can operate with line voltages from 100 to 230
VAC and at 50 Hz. or 60 Hz.
Fiber Optic Connection
Notice: Do not operate the illuminator without the fiber optic connected to the illuminator.
Loosen the fiber optic nosepiece thumbscrew.
Insert the fiber optic into the illuminator nosepiece.
Tighten the thumbscrew by hand to make a secure connection to the fiber optic. Use of pliers or
other tools is not recommended.
Two nosepiece styles are available with the DC950 series of fiber optic illuminators. A-type with a
0.985 in. (25mm) ID, or B-type with a 0.590 in. (15mm) ID smaller than the 0.985 in. ID.
A-type nosepieces require the use of adapters to mate fiber optic light guides smaller than the 0.985 in. ID.
Adapters fit into the nosepiece and reduce the ID to accept the chosen fiber optic. The fiber optic and the
adapter are secured with the thumbscrew. The following A-type adapters (SX-5, SX-6 & SX-7) are made
with an idler which allows quick disconnect of the fiber optic.
B-Type nosepieces will accept self-supporting goosenecks (EEG2823C, EEG3922C, BG2820C, etc.) and
ringlight (A3739B) fiber optics without the need for an adapter. Fiber optics smaller than the 0.590 in.
(15mm) ID will require the use of B-type adapters (SX-5B, SX-6B & SX-7B).
©2004 Dolan-Jenner Industries, 159 Swanson Rd., Boxborough, MA 01719
978-263-1400, FAX: 978-264-0292, 1-800-83-FIBER, http://www.dolan-jenner.com 05-530018-0000 Rev. F 10/06
DC950 ILLUMINATOR
A PRODUCT OF DOLAN-JENNER INDUSTRIES
Operation Manual
® Fiber-Lite