ETC Source Four LED v1.6.0 User Manual - Manual (Page 11)

Introduction 5
Safety
The Source Four LED Profile fixtures are intended for professional use only. Read the
entire User Manual before using equipment.
W A R N I N G : Note the following safety warnings before use:
•
Do not mount the Source Four LED Profile fixture on or near a flammable
surface.
• Do not use this fixture with a damaged power lead. If the power lead
(cordset) is damaged, it must be replaced.
• Do not use this fixture if glass lens is deeply scratched or cracked.
Damaged lenses must be replaced.
• Use theSource Four LED Profile fixture in dry locations only, where
humidity does not exceed 90 percent (non-condensing). These fixtures are
not intended for outdoor use.
• Mount and support the fixture only by the primary suspension holes in the
yoke or floor standing yoke.
• Suspend the fixture from a suitable structure using only the hardware rated
for the weight of the fixture.
• In addition to primary suspension, attach a safety cable (ETC Model 400SC
or other approved safety cable or device) to the fixture housing.
Appropriate attachment point (hole) is provided in the protruding tab on the
fixture housing.
• Disconnect the unit from power and DMX and allow the fixture to cool
before removing or installing the shutter barrel or other adapters, and all
cleaning and maintenance.
N o t e : • Maximum recommended ambient operating temperature: Ta=40°C (104°F)
• Maximum anticipated external surface temperature: Tmax=80°C (176°F)
• External temperature after 5 minutes of full-brightness operation at 25°C (77°F)
ambient: 29.9°C (85.8°F)
• External Temperature (steady state achieved) at 25°C (77°F): 41.5°C (106.7°F)