ETC Alex M Alex MX - Manual (Page 40)

Creating a chase with the chaser function Providing light automatically
– 40 –
Alex M
030430-150B
Alex_M_E_150C_A5.doc
Holding/terminating a chase
1 Press [Page] to call menu page 3,
Memory/Chaser.
2 Use the knob to move the selection
cursor to the CHASE field.
• The current status (GO__XX =) is
selected.
3 Press [Edit].
• The number of the preset that has
just been output disappears, but the
chaser function remains active.
Fig. 28: Holding a chase
4 Use the knob:
• To set the HOLD function to hold the chase.
The current output values are retained.
• To set the STOP function to terminate the chase.
The chase is faded out immediately.
Difference:
• HOLD: [SAVE] holds the chaser function; the current output values are retained.
• STOP: [SAVE] terminates the chaser function; the chase is faded out
immediately.
5 Press
[Save] to activate the selected function (HOLD or STOP).
Every time the chaser function restarts, it begins with the first preset in the
sequence, irrespective of whether HOLD or STOP was active last.