ETC SmartPack CE Wall Mount - Manual (Page 9)

Prepare for Installation 7
Cable Routing and Conduit Access
C A U T I O N : In order to maintain safety, proper air flow and cooling, do not leave any panels
removed unless facing an adjoined pack.
1 N 1 L1 2 N 2 L1 3 N 3 L1 4 N 4 L1 5 N 5 L2 6 N 6 L2
1 L
7 N 7 L2 8 N 8 L2 9 N 9 L3 10 N 10 L3 11 N 11 L3 12 N 12 L3
2 L 3 L 4 L 5 L 6 L 7 L 8 L 9 L 10 L 11 L 12 L
Rear
Rear
Rear
Rear
Removable plates on top and bottom.
Remove appropriate plate to punch
conduit access as needed for AC Input
and load wiring. Remove plate
permanently if SmartPack is mounted
below another SmartPack or SmartSwitch.
Removable plates on either side.
Remove appropriate plate to punch
conduit access as needed for AC Input
and load wiring. Remove plate
permanently if SmartPack is mounted
to the side of another SmartPack.
Top
Bottom
Righ
t Sid
e
Lef
t Side
Load Terminals
Access Holes for
mounting bolts or screws.
Earth/Ground Bus AC Input Lugs
Knockouts in the lower side
panels accommodate conduit
or bushes for low voltage
control wiring to the
I/O compartment.
I/O Compartment - all low-
voltage (control terminations
conveniently located in the lower
panel.