Ewbank Floor Scrubber & Polisher with Vac FP1000 - Manual (Page 5)

5
Assembling the Appliance
• Insert the handle into the aperture at the top
of the body until the metal securing knob is
located (Fig.3).
• Polisher base can be removed from the
appliance, press release clip (A) and pull
straight out (Fig.2).
Changing the pads and plates on your
product
• Make sure machine is not plugged in before
fitting pads.
• Note the orientation of the drive hubs (Fig.4).
• Place the required velcro-plate or brush plate
over the hub and rotate until the shape lines
up.
• Press the plate down to clip into place (Fig.6).
• Always use two plates of the same type, i.e.
not 1 brush and 1 pad (Fig.7).
• Simply pull the plates off to remove and
change.
Adjust the handle to suit your height (Fig.1).
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7 Fig.2
Fig.1
EB0491-FP1000-10.13_Layout 1 31/10/2013 11:11 Page 5