Ewbank Floor Scrubber & Polisher with Vac FP1000 - Manual (Page 8)

8
Power Cord Storage
• The electrical power cable can be stored on
the rear of the product using the convenient
power cable hooks.
Dismantling the Ewbank ® Floor Scrubber
& Polisher with Vac
• Depress the release clip on the rear of the
bottom section of the machine (1) and lift the
main body of the machine to remove it (see
page 5, Fig.2).
• Remove the dust container from the front of
the machine (see page 7, Fig.10).
• Depress the steel button, then pull the handle
section to remove it (see page 7, Fig.11).
Polishing the floor
• Clean floor thoroughly first before adding your
chosen floor wax polish.
• Allow to dry before buffing using blue
polishing pads.
• Switch to setting 1, the polishing function
WITHOUT the vacuuming function.
• With your foot securing the head of the
polisher on the floor, pull the handle towards
you and the machine will start.
• If you are using a floor polish or oil, refer to
the manufacturer’s instructions when using
with the Ewbank ® Scrubber & Polisher with
Vac.
• Move at a speed of about 1 minute every 1m 2
across the surface of the floor in the pattern
illustrated in (Fig.8).
• DO NOT leave the machine operating in one
area for a prolonged period of time as this
may damage your floor.
Cleaning and Maintenance
Cleaning the filters
• With the dust container removed, you will
have easy access to the filter and the filter
holder. The cyclone cone can also be
removed once the hinged bottom flap is open,
and the dust container empty.
• All these components are washable under the
tap – please take care as they are fragile.
• Once clean, the components may be left to
dry naturally. Please ensure that these parts
are completely dry before reassembling the
machine.
EB0491-FP1000-10.13_Layout 1 31/10/2013 11:11 Page 8