EZWatch Pro 4.0 - Manual (Page 116)

This Page is Blank
Page | 115 FCC Compliance
5 FCC Compliance
5.1 FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions. This device may not cause harmful interference, and this device must accept any
interference received, including interference that may cause undesired operation.
5.2 FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does not cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
Shielded cables and I/O cords must be used for this equipment to comply with relevant FCC
regulations.