EZWatch Pro 3.0 - Manual (Page 41)

41
z
Note: This is optional. You can read more about this in the Netcom operation manual.
Also, on the right side of toolbar, there is a bluish circle as Fig. 5-17
,
click and you can select a
camera to modify its P, S and A settings. If you are using a P-T-Z camera, you can only modify
A. Adjust the settings within A to set up your auto scan preferences. (Refer Fig.5-18).
Fig. 5-17 Fig. 5-18
If you happen to be using a Speed Dome camera, you can also adjust P (Preset positions) and S
(Speed of Motor). Note that pressing “A” when modifying a Speed Dome camera will give
different options more than if you were using a P/T/Z. Click on “P” to set preset positions
(Refer Fig.5-19). Adjust the camera to where you want it to view, and then press “Set”. You
can add as many as there is room. If you want to test settings by moving the camera to the
preset position, just press “Goto” and it will move to the position you set it to.
Pressing “S” on the menu bar will allow you to set the speed for this camera’s pan, tilt, and zoom.
Just slide the bar to your desired speed (Refer Fig.5-20). The above functions are for Speed
Dome camera only.
Fig. 5-19 Fig. 5-20