Flex TPO Для дома - Manual (Page 12)

FLASHING
General Flashing Conditions
Flex Reinforced Flashing Membrane is to be installed for the flashing
of parapet walls, roof equipment curbs, expansion joints and roof
dividers, and for most other roof detail flashing areas.
Flex non-reinforced flashing membrane may be used for those areas
where the use of pre-formed accessories cannot be installed such as
certain pipe penetrations, corners, and scuppers details.
Re-roofing Flashing Conditions
Existing flashings must be removed prior to installing the new Flex
Flashing Membrane. Termination Bar, surface mounted reglet, or surface
mounted counter flashings must be installed directly to the wall surface.
Application
Adhere the flashing membrane to walls, curbs and other vertical
surfaces with Flex Flashing Adhesive. The Flashing Adhesive is applied
to both the membrane and the surface to which it is bonded. The
coverage rate is dependent on the type of substrate but should average
approximately 60 square feet per gallon for both the membrane and
the substrate. The flashing adhesive is allowed to dry until it is tacky
and the flashing membrane is rolled into the adhesive.
Complete all seams of the flashing membrane by the hot air welding
method.
12
Applying flashing adhesive