BT Response 15+ - Manual (Page 13)

release the STOP
button.
Your Response 15 will
automatically play
back your message,
then beep to confirm
the recording. It will
then return to ‘answer
on’ mode
To re-record your
outgoing message,
repeat this procedure
To check your
outgoing message
Press and release the
STOP button
Your Response 15 will
beep and play back
your outgoing
message. It will then
beep again and return
to ‘answer on’ mode
To delete your
outgoing message
You can delete your
outgoing message
and return to your
Response 15’s pre-
recorded outgoing
message.
Press and release the
STOP button. Your
outgoing message will
be played back to you.
While the message is
playing, press the
DELETE button.
Your Response 15 will
beep and play its pre-
recorded outgoing
message.
Your own message has
now been replaced by
the Response 15’s
original pre-recorded
message.
9
1
2
2
1
1
To record your
outgoing message
speak clearly, 15 to
20cm from the in-built
microphone.
Your outgoing message
may sound something
like this: ‘Hello, I’m
sorry I can’t take your
call at present. If you
would like to leave a
message, please speak
after the tone.’
Read all the steps before
you begin recording.
Press and hold the
STOP button.
Your Response 15 will
beep with the display
flashing...
Keep holding down
the
STOP button and
say your message into
the microphone.
When you have
finished speaking,
Answer on
stop
stop
messages battery
low
In-built
microphone
Hello, your call cannot
be taken at the moment, so please
leave your message after the tone.
stop
delete
messages battery
low
stop
4th Edition – 13.10.98