General Machine Products 70524 Adams CD3 Continuous Duty Winch - Manual (Page 25)

AK 7/18/2012 ver 5
Model CD3 Winch Specifications
No other winch available anywhere offers you the same time-tested, rugged performance as the Adams Con-
tinuous Duty. Now the best cable pulling winch your money can buy comes loaded with new performance fea-
tures, and its more compact design takes up less than 25 in. of space on either side of the drum centerline with
no sacrifice in capacity. What's more, we've simplified the installation to give the Adams CD3 the lowest in-
stalled cost compared to any other continuous duty winch in its class!
Rated in compliance with SAE J706 Bare drum pulling capacity: 24,000 Ibs. (106.8 kN)
Check Out These Standard Features
Maximum Rate Line Pull & Line Speeds
Hydraulic Tri-Drive Three Speed Transmission
♦ Hydraulic system flow 30 GPM (114 1/min.) maximum; Hydraulic system pressure 2400 psi (16548 kPa)
operating with 2500 psi (17238 kPa) maximum relief valve setting.
♦ Winch line speed is based on 6 in. (14.3 mm) diameter wire rope.
♦ The line pull ratings shown are for the winch only. Consult the wire rope manufacturer/or wire rope
ratings.
♦ Selection of the proper wire rope diameter, with a minimum breaking strength and allowable pull appropri-
ate for use on these winches is the responsibility of the user.
♦ For information on wire rope sizes other than those shown, consult the factory.
1 For SAE rated wire rope capacities, use 90% of the values shown.
Diameter Ø in. 7/16 1/2 9/16
(mm) (11.1) (12.7) (14.3)
Length feet 2630 1890 1510
(meters) (802) (576) (460)
Drum Storage Capacities For Typical Wire Rope Diameters 1
Control Valve Max Rated Line Pull Winch Line Speed
Position Bare Drum Full Drum Bare Drum Full Drum
Ibs. force (kN) Ibs. force (kN) ft./min.(m/min.) ft./min.(m/min.)
High 7100 (31.6) 3800 (16.9) 113 (34.4) 210 (64.0) 40.8
Intermediate 13500 (60.1) 7300 (52.5) 72 (21.9) 134 (40.8) 26.0
Low 24000 (106.8) 13000 (57.8) 45 (13.7) 84 (25.6) 16.3
Shaft Speed
General Machine Products Co., Inc.
3111 Old Lincoln Highway Trevose, PA 19053 USA
TEL: 215-357-5500 FAX: 215-357-6216
E-MAIL: [email protected]
WEB: http://www.GMPtools.com
GMP reserves the right, without notice, to
make changes in equipment design or
components as progress in engineering or
manufacturing methods may warrant.
All contents ©2012 GMP GM-4156-497
Printed in USA
Highly efficient helical gears Free spool caliper drag brake
3-speed hydraulic transmission with control
valve providing true "shift-on-the-fly" SAE rated bolt-on mounting brackets
Air shift clutch
Full load brake - spring applied, hydraulic release Drum guard
25