General Machine Products Various Double "E-Loc Coupling" - Manual

INSTALLATION INSTRUCTIONS DOUBLE E - LOC ® COUPLINGS
Loosen Locknuts until 1” of thread is visible on each side of the body. Mark each conduit 3 1/4” from the
end (for 1” to 1 1/4 “ sizes), 3 3/8” from the end (for 1 1/2” sizes) or 3 7/8 “ for the end (for 2” sizes)
Push conduit into each end making sure each conduit is tight against
the center stop and inserted to the marked line
Mark Conduit Mark Conduit for insertion depth
Hand tighten each locknut
General Machine Products Co. 3111 Old Lincoln Highway Trevose, PA 19053 USA
Tel: +1.215.357.5500 Fax: +1.215.357.6216 Email: [email protected]
SOLD BY