General Machine Products Grip Pulling Single Weave-1 - Manual

Single weave grips should be laced with
single strand lacing.
Double weave grips should be laced with
double strand lacing.
Start lacing at the lead or anchoring end
of the grip. Thread the lacing through the
first two loops of the split and
pull through
until the laces are centered at this point.
Lace as you would your shoe, crossing
the laces before lacing the next two
loops.
Do not pull the lacing too tight. Leave a
space between adjoining loops approxi-
mately equal to the width of one diamond
of mesh.
Next twist the lacing strands tightly to-
gether at the tail end of the grip.
Finally, wrap the ends of the lacing once
or twice around the tail of the grip tightly,
twisting the ends together securely.
Any excess lace can now be cut off.
Lacing Instructions for
Double Weave-Double Flexible Eye Lace Up Grip
General Machine Products Co. 3111 Old Lincoln Highway Trevose, PA 19053 USA
Tel: +1.215.357.5500 Fax: +1.215.357.6216 Email: info@GMPtools.