General Machine Products Various 2 Piece Coated Aluminum Duct Couplings User Manual

General Machine Products Hardware

Advertising
background image

33079

SPLIT DUCT COUPLING INSTALLATION

1.

Using a tubing cutter, square cut the end of each duct and

remove burrs.

2.

Place 3 to 5 wraps of vinyl tape

around the middle of the butted duct
ends. Avoid using more than 5 wraps
and keep the tape in the area of the rub-
ber seal, away from the threaded areas of the coupler.
The seal in the coupler keeps the tape pressed tightly
to the butted joint to provide
the air-tight seal.

3.

Place the bottom half of the coupler (half with-

out the bolts) under the butted duct ends with the
taped area in the middle of the rubber seal on the
coupler.

4.

Place the top half over the duct and screw

the bolts into the bottom half finger tight.
Alternately tighten the bolts until clamp is tight.

For coupling P/N’s 70692,70693,70694,70695

GENERAL MACHINE PRODUCTS CO. INC.

3111 Old Lincoln Hwy. · Trevose, PA 19053

215.357.5500 ▪ www.gmptools.com

Advertising