GreenGuard Commercial Building Wraps - Manual (Page 14)

13
Large Damaged Areas
If the damaged area is large, a building wrap patch may be required. Begin by
making a cut several inches above the damaged area. Tuck the piece of building
wrap up underneath the cut with most of the building wrap piece extending out
over the building wrap on the wall. Then tape all edges of the building wrap patch
area as shown.
1-800-241-4402 www.TrustGreenGuard.com
B U I L D I N G W R A P A N D F L A S H I N G I N S T A L L A T I O N
15.0 REPAIRING BUILDING WRAP
Small Tears and Holes
Use GreenGuard® Custom Seam Tape or Flashing to cover small tears or holes.
Sealing at Mounting Boxes
Use GreenGuard® Flashing or GreenGuard® Custom Seam Tape to seal the
building wrap around the mounting box as shown.
Figure 14.4
Installation of flashing at mounting box. Figure 14.5
Installation of flashing at mounting box. Figure 14.6
Installation of flashing at mounting box.