Baracoda 2 - Manual (Page 39)

BaracodaPencil 2 – Communication Protocol v1.3 - 39 -
Data Capture
for Workforce
in Motion
Low Power (medium speed):
MinSniff = 0x0050
MaxSniff = 0x00F0
Attempt = 0x0008
Timeout = 0x0030
MaxSniff and MinSniff are only used for sniff negotiation between the Smart Module and the other
BT device. If both sides allow sniff value MaxSniff, then MaxSniff will be used. If the other side does
not accept Sniff values MinSniff to MaxSniff, no sniff will be used.
Values are in number of Bluetooth slots (1 slot = 625µs)
Set MinSniff and MaxSniff to 0 to disable Sniff.
MinSniff must be inferior to MaxSniff.
Possible values for MinSniff and MaxSniff are 0x12 to 0xFFFF.
Sniff attempts of 0 is not allowed.
Warning: Setting MaxSniff to 0xFF means a sniff period of 40s! You will have very very low data rate.
Note: This setting takes effect immediately.
For further details on Sniff values, see the Bluetooth spec 1.1, chapter 10.8.2
Command Get link timeout
Header 0x18
Length 00 00
Payload
Response 0x18 00 02 [MSB of link Tmo, LSB of link Tmo]
Remark
Command Set link timeout
Header 0x19
Length 00 02
Payload [MSB of link Tmo, LSB of link Tmo]
Response 0x19 00 01 01 if done
Remark The link Time Out is a multiple of 625µsec (625µs = 1 Bluetooth
slot) (default 0x7D00 (=20s))
This Timeout is use by the Link Manager to monitor the Bluetooth Link. If there is no answer from the
other device after this timeout, the Link Manager assumes that we are disconnected. By default, this
value is set to 20 seconds. You can go down to 1s, but then you can have disconnection even if it’s
only a temporary perturbation.
This value will take effect at the next connection.