INCRA TS-II Table Saw Fence - Manual (Page 12)

AUXILIARY FENCE MOUNTING
For some cutting operations, you may wish to add a wood-
en auxiliary fence to the front face of your TS II fence. A T-
slot is provided for mounting the auxiliary fence using
1 ⁄ 4 – 20 mounting screws, washers, and square nuts. Drill
and counterbore your wooden fence to recess the screw
heads and capture the nuts in the T-slot as shown in
Fig. 27. Hole centers should be located 1
3 ⁄ 4 " from the
bottom edge of the wooden fence. T-slots in the top of the
fence are provided to attach hold downs or other user-
made fixtures. Use
1 ⁄ 4 – 20 fasteners and square nuts for
these T-slots as well.
12
Made in America by:
Taylor Design Group, Inc.
■ P.O. Box 810262 ■ Dallas, Texas 75381 1097
Printed in the U.S.A. © 1997, Taylor Design Group, Inc. INCRA is a registered trademark of Taylor Design Group, Inc.
FIG. 27
Auxiliary fence
mounting
Wooden
auxiliary
fence
1 / 4 " flat
washer
1 / 4 – 20
screw
1 / 4 – 20
square
nut
1 3 / 4 "
PRODUCT INFORMATION
For a product information update on the complete
INCRA line of tools, please see your nearest dealer. If
you are unable to locate a store nearby, or if you have
trouble finding a particular product, we will honor your
order directly. For a product information brochure, call, write or fax to:
Taylor Design Group, Inc.
P.O. Box 810262, Dallas, TX 75381
Tel: (972) 418-4811 Fax: (972) 243-4277
Web Site: www.incra.com
WARRANTY
Taylor Design Group, Inc. warrants this product for one year from date of purchase. We will repair any
defects due to faulty material or workmanship, or at our option, replace the product free of charge.
Please return the failing component only, postage prepaid, along with a description of the problem to
the address below. This warranty does not apply to parts which have been subjected to improper use,
alteration, or abuse.
LIFETIME WARRANTY ON POSITIONING RACKS
If an INCRA positioning rack in this tool becomes damaged for ANY reason, Taylor Design Group will
replace it free of charge for as long as you own your tool. Return the damaged rack, transportation pre-
paid, and allow 1 to 2 weeks for delivery.
NOTE:
Replacements cannot be sent unless damaged racks have been received by Taylor Design Group.
MAINTENANCE
Your TS II is designed to give many years of virtually main-
tenance-free operation. In fact, just keeping your TS II clean
is all you need to do to keep the tool in top shape.
Occasionally, remove the carriage from the base and brush
or blow out any sawdust or debris that may have accumulat- ed. Use a toothbrush to clean the teeth on the INCRA racks
on both the carriage and the base. A light application of
paste wax to the top of the rails from time to time will keep
the rails smooth and clean.
Use 1 / 4 – 20 square
nuts in the accessory
T-slots to attach
shop-made fixtures or
hold downs