Rail assembly – INCRA TS-II Table Saw Fence User Manual
Page 4
4
Unplug your table saw and remove the existing fence,
including the front and rear support rails, mounting brackets,
and the blade guard.
Note: The blade guard must be reinstalled after you have fin-
ished mounting the INCRA TS II to your table saw.
Attach mounting brackets
Attach (4) mounting brackets to the cast iron surface
of your table saw using the supplied hardware. See Fig. 1.
The Mounting Bracket Hardware Pack contains a variety of
fasteners which will work with most table saws. Use the
largest bolts in the pack that will fit your saw’s existing
mounting holes. If the holes in your table saw are threaded,
use the bolt/washer arrangement shown in Detail 1A. If the
mounting holes are not threaded, use the bolt/washer/nut
arrangement shown in Detail 1B. Position the mounting
brackets
1
⁄
4
" below the table top as shown in Details 1A
and 1B and snug the fasteners to hold the brackets in
place. DO NOT TIGHTEN THE BOLTS AT THIS TIME.
(Discard any remaining fasteners from the Mounting Bracket
Hardware Pack.)
Loosely attach rail bolts
Open the Rail Hardware Pack. Add a
3
⁄
8
" flat washer
to each of (4)
3
⁄
8
–16 x
3
⁄
4
" hex bolts. Place the bolts
through the holes in the mounting brackets and loosely
attach the
3
⁄
8
–16 rectangular nuts. See Fig. 2 above.
Slide rails onto mounting
brackets and tighten bolts
Carefully slide the rails onto the mounting brackets so that
the rectangular nuts are captured in the T-slot on the bottom
of the rail. Fig. 3 shows the correct orientation for the front
and back rails. Approximately center the length of the rails
on your table saw and tighten the mounting bolts that
secure the rails to the brackets.
FIG. 1
Attach rail mount-
ing brackets
Use appropriate mounting hard-
ware from the Mounting
Bracket Hardware Pack to
attach brackets
(See Details 1A and 1B)
Rail mount-
ing brack-
ets
Threaded holes
in table saw
Lock washer
Through holes
in table saw
(Not threaded)
Hex
nut
1
Flat
washer
Flat washer
Lock washer
Web
RAIL ASSEMBLY
DETAIL 1A
DETAIL 1B
FIG. 2
Loosely
attach rail
bolts
2
3
Orient rails so that web is vertical
and off center T-slot faces the saw
as shown below
Front rail
Rear rail
Off center T-slot faces table saw
Web
FIG. 3
Front and rear
rail orientation
1
⁄
4
"
Table saw top
Table saw
top
3
⁄
8
– 16 rectangular nut
Mounting
bracket
3
⁄
8
– 16 x
3
⁄
4
" hex bolt
3
⁄
8
" flat washer
1
⁄
4
"
Table saw