INCRA TS-II Table Saw Fence - Manual (Page 2)

3 ⁄ 8 – 16 x 1 1 ⁄ 2 "
hex bolt
3 ⁄ 8 "
flat washer
3 ⁄ 8 "
lock washer
3 / 8 – 16
hex nut
3 ⁄ 8 – 24 x 1"
hex bolt
5 ⁄ 16 – 18 x 1 1 ⁄ 2 "
hex bolt
5 ⁄ 16 "
flat washer
5 ⁄ 16 "
lock washer
5 ⁄ 16 – 18
hex nut
2
■ Before using the INCRA TS II, read and follow all of
the instructions and safety information in this manu-
al.
■ When using the INCRA TS II in conjunction with any
other tool, first read and follow all instructions and
safety information in that tool’s owner’s manual.
■ Never let any part of the INCRA TS II interfere with
another tool’s safety guards or other safety equip-
ment.
■ Before using your INCRA TS II, make sure all
mounting screws are tight and that the black clamp-
ing knobs are securely tightened to the rails.
■ Always turn off the power and make sure that the
blade is fully stationary before changing the setting
on any part of the INCRA TS II.
■ Always keep both hands behind the fence when
moving the INCRA TS II to a new setting.
■ Before making a cut, always make sure that the car-
riage clamp is fully engaged and that the
rail hook thumbscrew is securely tightened.
■ Use appropriate safety devices. Keep hands clear
of the saw blade! Always use a push stick, rubber
soled push block, or other safety devices to keep
your hands safely away from the saw blade.
■ Never let the saw blade come into contact with any
part of the INCRA TS II or INCRA Jig Ultra.
■ Wear safety glasses, hearing protection, and follow
all normal shop safety practices.
■ Never operate your table saw without a blade guard.
SAFETY
FASTENERS
(actual size)
Mounting Bracket Hardware Pack
Contents:
6 ea. ...... 3 ⁄ 8 –16 x 1 1 ⁄ 2 " hex bolt
4 ea. ...... 5 ⁄ 16 –18 x 1 1 ⁄ 2 " hex bolt
2 ea. ...... 3 ⁄ 8 –24 x 1" hex bolt (Delta
Unisaw)
6 ea. ...... 3 ⁄ 8 " flat washer
4 ea. ...... 5 ⁄ 16 " flat washer
6 ea. ...... 3 ⁄ 8 " lock washer
4 ea. ...... 5 ⁄ 16 " lock washer
6 ea. ...... 3 ⁄ 8 –16 hex nut
4 ea. ...... 5 ⁄ 16 –18 hex nut
Note: Extra hardware is provided
in this pack to ensure compatibility
with a wide variety of table saws.
Only four of the bolts will be used
in a typical installation.
Important safety instructions for using the INCRA TS II.