Safety, Safety fasteners – INCRA TSIII Table Saw Fence User Manual
Page 2
6 each
3
⁄
8
– 16 x 1
1
⁄
2
"
hex bolt
6 each
3
⁄
8
"
flat washer
6 each
3
⁄
8
"
lock washer
6 each
3
/
8
– 16
hex nut
2 each
3
⁄
8
– 24 x 1"
hex bolt
(Delta Unisaw)
4 each
5
⁄
16
– 18 x 1
1
⁄
2
"
hex bolt
4 each
5
⁄
16
"
flat washer
4 each
5
⁄
16
"
lock washer
4 each
5
⁄
16
– 18
hex nut
■
Before using the INCRA TS III, read and follow all
of the instructions and safety information in this
manual.
■
When using the INCRA TS III in conjunction with
any other tool, first read and follow all instructions
and safety information in that tool’s owner’s manual.
■
Never let any part of the INCRA TS III interfere with
another tool’s safety guards or other safety
equipment.
■
Before using your INCRA TS III, make sure all
mounting screws are tight and that the black
clamping knobs are securely tightened to the rails.
■
Always turn off the power and make sure that the
blade is fully stationary before changing the setting
on any part of the INCRA TS III.
■
Always keep both hands behind the fence when
moving the INCRA TS III to a new setting.
■
Before making a cut, always make sure that the
carriage clamp is fully engaged and that the
rail hook thumbscrew is securely tightened.
■
Use appropriate safety devices. Keep hands clear
of the saw blade! Always use a push stick, rubber
soled push block, or other safety devices to keep
your hands safely away from the saw blade.
■
Never let the saw blade come into contact with
any part of the INCRA TS III or INCRA Jig Ultra.
■
Wear safety glasses, hearing protection, and follow
all normal shop safety practices.
■
Never operate your table saw without a blade guard.
SAFETY
FASTENERS
(actual size)
Mounting Bracket Hardware Pack
Note:
Extra hardware is provided in this pack to
ensure compatibility with a wide variety of
table saws. Only four of the bolts will be
used in a typical installation.
Important safety instructions for using the INCRA TS III.
INCRA Woodworking Tools & Precision Rules
2