INCRA TSIII Table Saw Fence - Manual (Page 7)

Set final base assembly
position
Loosen the (4) base clamping knobs and slide
the base assembly to locate the near side of the
base support panel at 36" from the saw blade.
See
Fig. 14. Tighten the clamping knobs in
place. Using a 3 ⁄ 16 " hex tool, tighten the (4) set
screws through the holes located in the base
clamps. Slide the (2) stop positioners up
against the base clamps as shown and tighten
the hex bolts. Should you ever need to remove
the base assembly from your table saw, these
stop positioners will allow you to return to the
original setup in seconds.
6
Align base mount assembly
parallel to miter slot
Take the base mount assembly to the
table saw and as you lower the base mount
onto the rails, position the (4) clamping knob
assemblies directly under the slots in the base
clamps. Slide the base assembly along the rails
to position the base support panel at 20" from
the miter slot,
Fig. 13. Take a measurement at
both ends of the panel. Loosen the phillips
head screws that hold the base clamps as
necessary to align the panel parallel to the miter
slot. Tighten the four base clamping knobs,
then tighten all eight screws that secure the
base clamps to the base support panel.
Replace the base support panel end caps.
FIG. 14
Set final base assembly position
Base clamp
36"
First: Slide base assembly to
36" from saw blade and
tighten all (4) clamping knobs
3 ⁄ 16 " hex tool
INCRA TS III Owner’s Manual 7
5 FIG. 13
Align base mount assembly parallel to miter slot
Loosen base clamp
screws as necessary
Base clamp
Base support
panel
20"
Third: Tighten base clamping knobs
and all eight screws that secure the
base clamp to the support base
Miter slot
By loosening the (4) clamping
knobs and set screws you can slide
the base assembly to any position
along the length of the rails – great for
accessing a router table extension wing
placed to the left of the blade.
Replace
end caps
First: Lower base
assembly onto rails and
base clamping knobs
Second: Slide base
assembly to align base
support panel 20" from
and parallel to miter slot
Base
clamping knob
Third: Slide stop
positioners up to both
base clamps and
tighten hex bolts Second: Tighten (4)
set screws through
holes in base clamps