Intelix FLX-88 - Manual (Page 14)

FLX-88 Installation Guide
To use the RS232 extension capabilities of the FLX-BI4 and FLX-BO4A, connect the TX, ground,
and RX control signal wires to the removable 3-pole terminal block. Consult the manual of the
control device(s) to determine which pins the TX/RX signals are carried on. Be sure to always
connect TX to RX and RX to TX.
FLX-RI4 Wiring
For VGA signals, use a standard VGA male to VGA male cable.
For RGBHV signals, use a standard VGA to RGBHV cable. Below is a common pinout of this type
of cable.
14