JULABO EH-39 Open Bath Circulator - Manual (Page 17)

EH
17
5.3. Filling / Draining
Notice:
 Pay attention to the thermal expansion of bath oil during heating to avoid
overflowing of the liquid.
 Do not drain the bath fluid while it is hot!
Check the temperature of the bath fluid prior to draining (by switching the
unit on for a short moment, for example).
 Store and dispose the used bath fluid according to the laws for
environmental protection.
Filling
 Take care that no liquid enters the interior of the circulator.
 Recommended maximum filling level with water as bath fluid:
20 mm below the tank rim
 Recommended maximum filling level with bath oils:
30 mm below the tank rim

After filling, immerse the samples in the bath or place the lid on
the bath, in case the opening is not to be used.
Draining
 Press the mains switch to turn the circulator off.
 Remove the circulator from the bath tank.
 Empty the bath tank.