JULABO SW23 Shaking Water Baths - Manual (Page 15)

Shaking Water Baths
15
 Check the filling level of the bath fluid from time to time. The heater must
always be fully covered with the bath fluid!
 Never operate the unit without bath fluid in the bath.
 Do not drain the bath fluid while it is hot!
Check the temperature of the bath fluid prior to draining (by
switching the unit on for a short moment for example).
 Never operate damaged or leaking equipment.
 Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or before
moving the unit.
 Transport the unit with care.
 Sudden jolts or drops may cause damage in the interior of the unit.
 Always empty the bath before moving the unit.
 Never operate equipment with damaged mains power cables.
 Observe all warning labels.
 Never remove warning labels.
 Condensation that could appear in and on other units near the water bath
may result in reduced operating safety.
Be careful when setting up and operating the water bath!
 Always turn off the unit and disconnect the mains cable from the power
source before cleaning the unit.
 Repairs are to be carried out only by qualified service personnel.
 Some parts of the bath cover may become extremely warm during
continuous operation.
When lifting the bath cover, pay attention to hot steam!
 Be careful when touching these parts!
 Use safety glasses!