JUMO 705040 mTRON T - Router Module Operating Manual - Manual (Page 18)

1 Introduction
18
1.3 Content of the technical documentation
The documentation for the measuring, control, and automation system is intended for plant
manufacturers and users with specialist training. It has a modular structure and comprises dif-
ferent sections.
1.3.1 Device documentation in printed form
B 7050XX.4
Installation instructions
A hard copy of the installation instructions is included in the scope of delivery of every module.
The installation instructions describe the installation of the device and the connection of the
supply and signal cables. They also contain the order details and a list of technical data.
The scope of delivery for a power supply unit includes a hard copy of the operating instructions.
These include information on installation and electrical connection.
B 705000.0
System manual
A hard copy of the system manual can be provided as an accessory subject to charge.
The system manual describes the scope of services of the measuring, control, and automation
system and provides all information for project design and startup.
Index divider 1 "System description" summarizes the information applicable to all modules.
Module-specific descriptions in the following sections complement the specifications stated
here.
Index divider 2 "Setup program" describes the project design of the overall system.
1.3.2 Device documentation in the form of PDF files
The device documentation files specified below are saved as PDF files on the DVD contained
in the scope of delivery of a base unit.
T 705000
Data sheet
The data sheet provides general information on the measuring, control, and automation system
and forms the basis for plant planning and purchase decisions.
T 7050XX
Data sheet
The data sheets of the individual modules provide specific information, order details, and tech-
nical data.
B 7050XX.0
Operating manual
The operating manuals of the individual modules contain all information on installation, electri-
cal connection, startup, operation, and – if required – parameterization and configuration.