JUMO 705030 mTRON T - Digital Input/Output Module Operating Manual - Manual (Page 43)

43
7 Online parameters
7.1 Calibrate / test
7.1.1 Digital output
Setup dialog
Parameters
NOTE!
An active connection between the setup program and the central processing unit is required
to configure the parameters described in this section.
CAUTION!
Incorrect settings may result in inadmissible changes to values.
This can have negative effects on the system function.
This function must be used only by (or under the instruction of) a service technician of the
device manufacturer.
Parameters Selection/settings Description
BinaryIO 1
to
BinaryIO 12 Select digital output (activate checkbox).
You can select multiple outputs simulta-
neously. The selected digital output changes to
active state (High level).
Set all Click the "Set all" button. All digital outputs change to active state
(High level).
Delete all Click the "Delete all" button. All digital outputs change to inactive
state (Low level).