JUMO 705015 mTRON T - Relay Module 4-Ch. Operating Manual - Manual (Page 39)

39
7 Online parameters
7.1 Calibrate / test
7.1.1 Digital output
Setup dialog
Parameter
TIP!
An active connection between the setup program and the central processing unit is required
to configure the parameters described in this section.
CAUTION!
Incorrect settings may result in inadmissible changes to values.
This can have negative effects on the system function.
This function must be used only by (or under the instruction of) a service technician of the
device manufacturer.
Parameter Selection/settings Description
Relay 1
to
Relay 4
Select relay (activate checkbox).
Several relays can be selected. The selected relay switches to operating
position.
Set all Click the "Set all" button. All relays switch to operating position.
Delete all Click the "Delete all" button. All relays switch to idle position.