JUMO PCA3000 PC Evaluation Software - Manual (Page 59)

59
9 Evaluation - Table area
Select
columns Using this function, individual columns of the active table can be switched into
or out of display.
v “Columns” on page 44
Zoom diagram
to batch period
(batch range) The measurements of the selected batch are zoomed to the next displayable
period and are graphically presented.
Scroll diagram
to batch period
(batch range) If the start time of the batch data is not within the visible time period, for
example after zooming, then “Scroll batch period” is used to shift the curves
so that the start time (or the next possible one) is in line with the left window
border.
Synchronize
batch period
(batch range)
to diagram The entry that matches the displayed measurements is searched for in the
table area and captured. The time shown at the left window border is decisive
here.
Search batch Specific batch documentation can be found by means of the “Search for
batch” function. The search can be made easier by applying different criteria.
Without the specification of criteria, all batch documentation is searched for.
Before you can enter a search criterion, it must be activated. Active search
criteria can be recognized by the
. All activated search criteria are AND-
linked.
Continue
search for
batch The “Continue search for batch” function, which is only available if the “Search
for batch” function has been performed, repeats a defined search for a
specific batch documentation.
Filter batch “Filter batch” serves to reduce the list of available batches.
Before you can enter a filter, it must be activated ( ).
The display in the header informs you that the current display is a filtered sel-
ection.
The batch filters refer to the individual columns in the batch list, i.e. one filter
criterion can be defined for each column. A batch will only be displayed when
all active column filter criteria have been fulfilled.
All active column filters and the full-text search are AND-linked.