JUMO 706581 LOGOSCREEN nt Operating Instructions - Manual (Page 10)

1 Introduction
10
1.3 Typographical Conventions
Warning signs
The signs for Danger and Caution are used in this manual under the following
conditions:
V
Danger
This symbol is used when there may be danger to personnel if the
instructions are ignored or not followed correctly!
A
Warning
This symbol is used when there may be damage to equipment or data if the
instructions are ignored or not followed correctly!
E
Warning
This symbol is used where special care is required when handling
components liable to damage through electrostatic discharge.
Note signs
H Note
This symbol is used when your special attention is drawn to a remark.
v Reference
This symbol refers to further information in other manuals, chapters or
sections.
h
Action instruction
This symbol indicates that an action to be performed is described.
The individual steps are marked by this asterisk, e.g.
h Rotate control knob
h Press control knob