JUMO 706510 LOGOSCREEN 500 cf Operating Manual - Manual (Page 55)

55
3 Operation and visualization
3.8 Text entry
Entry options The configurable texts can be entered either through the setup program or on
the instrument itself. This section describes the entry on the instrument.
Character
selection The display below is shown when a text (e. g. Configuration ➔ Texts) has been
selected at the configuration level for editing using
E .
After the character to be altered has been selected and the switch made to
character set matrix, the cursor is positioned on the current character in the
character set matrix.
Character entry The softkeys change their function, as can be seen from the picture below:
After the entire text has been entered, it can either be accepted or all
alterations canceled.
h Enter text with E
or
h cancel text entry with D
Switch to character set matrix
Select the character to be altered using the softkeys
Accept character
Select new character