JUMO 603070 heatTHERM-AT/heatTHERM-DR Data Sheet - Manual

Page 1/15
JUMO GmbH & Co. KG
Delivery address: Mackenrodtstraße 14
36039 Fulda, Germany
Postal address: 36035 Fulda, Germany
Phone: +49 661 6003-0
Fax: +49 661 6003-607
E-mail: [email protected]
Internet: www.jumo.net
JUMO Instrument Co. Ltd.
JUMO House
Temple Bank, Riverway
Harlow, Essex CM20 2DY, UK
Phone: +44 1279 635533
Fax:
+44 1279 635262
E-mail: [email protected]
Internet: www.jumo.co.uk
JUMO Process Control, Inc.
6733 Myers Road
East Syracuse, NY 13057, USA
Phone: 315-437-5866
1-800-554-5866
Fax: 315-437-5860
E-mail: [email protected]
Internet: www.jumousa.com
JUMO heatTHERM-AT and JUMO heatTHERM-DR
Type 603070, Surface-Mounted or Room Thermostat Versions
Special features
• -connection technology - reduced installation time by 50 %
• Stable switching point position due to ambient temperature compensation (standard)
• Max. switching capacity 16 A, 230 V
• Tested according to DIN EN 14597
• Operating life at least 250,000 switching cycles for TR and TW
• Switching point deviation during the entire operating life of up to ± 5 %
• Protection type max. IP 54
• UL approval (extra code 061)
Brief description
High application flexibility and the latest connection technology are the essential equipment
features of this new thermostat series.
The thermostat case is suitable for all common installation types such as wall mounting, immer-
sion sleeve, and contact fastening. It can be used universally and reduces the variant range be-
cause different mounting types must no longer be taken into account.
The JUMO heatTHERM-DR (type 7+8) type is a specific variation with a special housing bottom
section for DIN rail or wall mounting. As a result, easy mounting on mounting rails TH35 accord-
ing to DIN EN 60715 (e.g. in control cabinets) is possible. This variant considerably reduces the
mounting time. The flue gas automatic reset temperature limiter JUMO heatTHERM-AT locks
the gas/oil vessel that is connected in parallel with the wood vessel to a chimney.
For these international innovative surface-mounted thermostats with "Push-In
®
" terminal tech-
nology, the connection wires are only inserted into the terminal point up to the stop - that's it!
No tool is required for connecting the wire or strand with a ferrule and the wiring becomes safer.
In this manner, the costs and time required for connection are considerably reduced compared
to the conventional screw terminal.
The "Push-In ® " terminal technology allows direct switching of loads up to 16 A at 230 V AC. The
installation costs can be reduced further because a load contactor is no longer required.
Available are temperature controllers (TR), temperature monitors (TW), safety temperature mon-
itors (STW), safety temperature limiters (STB) as single or double thermostats, and flue gas tem-
perature monitors (ATW).
Approvals according to DIN EN 14597, DGRL, and UL indicate the high quality standards for
this product series.
Type 603070/0170 (TR/STB)
Type 603070/0001 (TR)
Type 603070/ 0002 (TW)
Type 603070/0002 (TW)
Approvals/approval marks (see "Technical Data")
* Only with extra code 061 Design type 5+6* Design type 7+8*
DGRL
97/23/EG
Data Sheet 603070
2013-03-15/00485234