JUMO 707040 dTRANS T04 - 4-Wire Transmitter Data Sheet - Manual

Page 1/8
JUMO GmbH & Co. KG
Delivery address:Mackenrodtstraße 14,
36039 Fulda, Germany
Postal address: 36035 Fulda, Germany
Phone:
+49 661 6003-0
Fax: +49 661 6003-607
e-mail: [email protected]
Internet: www.jumo.net
JUMO Instrument Co. Ltd.
JUMO House
Temple Bank, Riverway
Harlow, Essex CM20 2DY, UK
Phone: +44 1279 635533
Fax:
+44 1279 635262
e-mail: [email protected]
Internet: www.jumo.co.uk
JUMO PROCESS CONTROL INC.
885 Fox Chase, Suite 103
Coatesville PA 19320, USA
Phone:
610-380-8002
1-800-554-JUMO
Fax: 610-380-8009
e-mail: [email protected]
Internet: www.JumoUSA.com
dTRANS T04
Type 707040/...
2009-03-06/00443951
JUMO dTRANS T04
Four-wire Transmitter, settable via
DIP switch/PC setup program
for connection to Pt100/Pt1000 resistance thermometer
or potentiometer; rail-mounted to EN 60715
Brief description
These transmitters are designed for industrial applications and are used to measure the
temperature or resistance through a Pt100 or Pt1000 resistance sensor or potentiometer in
2-wire or 3-wire circuit connection.
The 0 — 20 mA, 4 — 20 mA or 0 — 10 V output signal is available linear with temperature/
resistance. The continuous analog signal path enables a fast reaction of the output to a
temperature change (analog continuous measurement instead of digital sampling rate).
This results in a low-noise output signal that is immune to interference. High precision, even
with small ranges, is ensured by the range-specific gain adjustment.
The transmitter can be set either on the instrument itself, via DIP switch, or through the PC
setup program.
Block structure
Controls
The chosen measuring range and
output response can be set via DIP switch.
Using the PC setup program,
additional ranges and parameters
are configurable.
JUMO
dTRANS
T04
Output
Current output
0 — 20 mA or 4 — 20 mA
Supply
0 10 V —
Configuration
- via setup interface
and PC setup software
- via DIP switch without PC
Supply
110 — 240 V AC +10/-15 %
48
63 Hz
or
20
53 V AC/DC, 48 63 Hz
—
— —
Input (707040/1...)
Resistance thermometer
Pt100, in 2- or
3-wire circuit
or
Input (707040/2...)
Resistance thermometer
Pt1000, in 2- or
3-wire circuit
or
Input (707040/3...)
Potentiometer, in 2- or
3-wire circuit
Data Sheet 70.7040
Key features
k Measuring range selectable via DIP
switch or through the PC setup
program
k Choice of signal output:
0 — 10V, 0 — 20mA or 4 — 20mA
k Fast response, thanks to
continuous analog measurement
k Low-noise current signal,
immune to interference
k Electrical isolation
between input, output / mains supply
k Current/voltage output