JUMO 902815 Dtrans T100 Screw-In RTD Temperature Probe Without/With Transmitter Operating Manual - Manual (Page 20)

20
6 Technical data
Overrange Linear rise up to 20.5 mA
(according to
NAMUR recommendation 43)
Probe short-circuit/
probe or lead break ≤ 3.6 mA or ≥ 21.0 mA (configurable)
Current limiting
on probe short-circuit
or probe break ≤ 25 mA
Output
Output signal Proportional DC current
4 to 20 mA, 20 to 4 mA
Transfer characteristic Linear with temperature
Maximum burden (R
B
) R
B
= (U
b
- 8 V) devided by 23 mA,
max. 600 Ω
Burden error ≤ ±0.02 % per 100 Ω
The % value refers to the range end value
20 mA
Settling time on a
temperature change ≤ 5 s
Settling time after a
switch-on or reset ≤ 5 s
Measuring accuracy
of electronics 0.1 °C or 0.08 %
The % value refers to the measuring span
that was set, the larger value applies
Electrical data
Voltage supply
(U
b
)
DC 8 to 35 V (pin 1 = +, pin 3 = -),
operation solely with SELV or PELV-
transmitter supply
(according to DIN EN 61140)
Protection rating III (according to DIN 61140)